FUTABA FX-36 Instruction Manual page 130

Flap setting
The up/down travel of each flap (camber flaps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently at each servo according to the wing type.
The operation reference point of each ap can be
offset
The camber aps of a 4- ap model can be mixed
with the brake aps. (Brake FLP to camber FLP)
An ON/OFF switch can be set.
Select [Flap setting] at the model menu and
call the setup screen shown below.
Return to Model menu
Up side/Down side
adjustment
Operation reference
point offset
Up side/Down side
adjustment
Operation reference
point offset
Setting method
Tap ap (FLP) 1~4 up or down according to
the wing type.
Adjust the travel independently.
To offset the operation reference point of
each ap, tap the corresponding offset item.
Use the " " " " " " "
the reference point.
When using brake FLP to camber FLP mixing,
130 ＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
[Corresponding model type]: Airplane/
glider, 2 aps or more]
Currently selected condition name
Camber flap setting
Operation is performed via the volume
switches, etc., set for each flap control of the
function.
Brake flap to Camber flap setting
" button to offset
FLP 3
(Brake Flap)
FLP 1
(Camber Flap)
Condition group/single
mode selection (Gr. /Sngl)
(For more information, see
the description at the back
of this manual.)
Brake flap setting
The operational volume
switch is set up by "Function"
Mixing
INH ⇔ ON
The ON/OFF switch of
mixing is chosen.
tap the [INH] item and tap the screen. (ON is
displayed.)
When setting a switch, tap the [--] item of
the switch and tap the screen to call the
selection screen. Then, select the switch and
set its ON direction. (Always ON at "--" setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
FLP 4
(Brake Flap)
FLP 2
(Camber Flap)
*The display screen is an
example. The actual screen
depends on the Model
Type.