Servo Speed; Sub-Trim - FUTABA T18SZ Instruction Manual

Servo speed

The Servo speed setting is used to set the servo
delay for each channel, from channel l to channel
16. The system uses the programmed speed (delay)
to slow down servo position changes. The Servo
● Tap the [Servo speed] button in the Linkage
menu to call the setup screen shown below.
●Return to Linkage menu
Servo speed setting
1. Tap the speed button of the channel you
want to set.
2. Use the value input buttons to adjust the
servo speed.
●Initial value: 0
●Adjustment range: 0~27 (steps)

Sub-trim

The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
● Tap the [Sub-trim] button in the Linkage menu to
call the setup screen shown below.
●Return to Linkage menu
Sub-trim adjustment
1. Tap the trim display part of the channel you
want to adjust.
Value input buttons appears on the Sub-trim
menu screen.
76
＜ Linkage menu ＞
Sets the speed of each servo.
speed setting can be varied from 0 to 27 in each
channel.
（First） 0 ～ 27 （Slowly）
3. Repeat this procedure for each channel.
To close this screen, tap the [Servo speed]
button.
Setting of neutral position of each servo.
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
2. Use the value input buttons to adjust the sub
trim.
●Initial value: 0
●Adjustment range: -240~+240 (steps)
*See above
3. Repeat this step for each channel.