Table of Contents
Advertisement
Telemetry : Temperature
Temperature is a screen which displays/sets
up the temperature information from an optional
temperature sensor.
The temperature of the model (engine, motor,
battery, etc.) which is ying can be displayed.
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
Tap the [Temperature] button in the Telemetry
screen to call the setup screen shown below.
Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
w i l l s h o w t h a t a n
alarm will sound when
the temperature rises
above the set value.
↓ A downward arrow
w i l l s h o w t h a t a n
alarm will sound when
the temperature drops
below the set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
Alert set : Temperature warning
1. Tap Alarm and choose from Bu er, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if not using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [℃ ] item .
4. Adjust the rate using the "
buttons.
Initial value: 100℃ 0℃
Adjustment range: -20℃ ~200℃
( Limit ≧ Limit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the H/E button.
*A temperature sensor must be installed in the aircraft.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
*The FASSTest18CH /T-FHSS mode can use all the telemetry
" " " " " "
"
Displaying data from the temperature
FASSTest12CH mode.
functions.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
＜ Linkage menu ＞
Temperature
Sets the temperature
on which the alarm
operates.
97
Advertisement
Table of Contents
