Table of Contents
Advertisement
Attachment of the battery
1. Open the rear case.
Band
Battery
6.0V- 7.4V battery
.
atter s
e
.
nnect the atter c nnect r.
.
se the rear case c
Connector
s n t
an s.
p ete .
Battery removal
Note: If you remove the battery while the
power is on, the data you have set will not
be saved.
1. Open the rear case.
.
sc nnect the atter c nnect r.
.
an s are re
battery.
.
se the rear case c
WARNING
Be careful not to drop the battery.
Never disconnect the battery connector from
the FX-36 transmitter after turning off the
power until the screen is completely blank and
the transmitter has shut down completely.
* Internal devices such as memories may be damaged.
* If there is any problem, the message "Backup Error"
will be shown the next time when you turn on the
power of the transmitter. Do not use the transmitter
as it is. Send it to the Futaba service center.
Charge the transmitter battery before using it for
the first time. To do this insert the transmitter
charging lead into the charging socket of a
charger correctly then connect the other end of the
charging lead to the charging jack on the left side of
FX-36 see page 2 . Start charging as described
in the manual of your charger. The transmitter must
be switched off during charging.
Note:
The charger must be able to charge 5-cell NiMH
rechargeable batteries. The charging current
must be limited to 1.5 A. Please refer to the user
manual of the charger.
e an the re
p ete y.
＜ Before Use ＞
17
e the
iMH
Advertisement
Table of Contents
