Servo Speed - FUTABA T18SZ Instruction Manual

Servo speed

Tap the [Servo speed] button in the Linkage
menu to call the setup screen shown below.
Return to Linkage menu
Servo speed setting
1. Tap the speed button of the channel you
want to set.
2. Use the value input buttons to adjust the
servo speed.
Initial value: 0
Adjustment range: 0~27 (steps)
Sub-trim
Tap the [Sub-trim] button in the Linkage menu to
call the setup screen shown below.
Return to Linkage menu
Sub-trim adjustment
1. Tap the trim display part of the channel you
want to adjust.
Value input buttons appears on the Sub-trim
menu screen.
76 ＜ Linkage menu ＞
Sets the speed of each servo.
（First） 0 ∼ 27 （Slowly）
3. Repeat this procedure for each channel.
To close this screen, tap the [Servo speed]
button.
Setting of neutral position of each servo.
2. Use the value input buttons to adjust the sub
trim.
Initial value: 0
Adjustment range: -240~+240 (steps)
3. Repeat this step for each channel.