Table of Contents
Advertisement
Function
When you select model and wing (swash) types,
you will find that the optimized combinations of
servo output channels and functions have been
already preset. If you would like, on the function-
setting screen of the linkage menu, you can freely
change combinations of servo output channels,
functions (aileron, elevator, etc), and input
controllers (sticks, switches, trim levers and trim
switches). You can also assign the same function to
multiple servo output channels such as assigning
elevator function to CH2 and CH3.
Tap the [Function] button in the Linkage menu
to call the setup screen shown below.
Return to
Linkage menu
Function change
1. Tap the function button of the channel you
want to change to call the Function select.
2. Select the function you want to change.
74
＜ Linkage menu ＞
Channel assignment for each function can be changed to suit your needs.
DG1, DG2 (switch channels)
These two channels can be used as switch (On/
Off) channels. You can freely change combinations
between servo output channels and input controllers
(sticks, switches, trim levers and trim switches).
Channel restrictions by a System Type
FASSTest 18CH---16 CH+2 Switch
FASSTest 12CH---10 CH+2 Switch
FASST MULTI ---16 CH+2 Switch
FASST 7CH
--- 7 CH
S-FHSS
--- 8 CH
T-FHSS
---16 CH+2 Switch
Operation control change
1. Tap the control button of the channel you
want to change. A control select screen
(stick, switch, knob, trim lever, etc.) is
displayed.
2. Select the control you want to operate.
*The same control can be assigned to multiple channels.
Advertisement
Table of Contents
