Table of Contents
Advertisement
Sensor : Change slot
This procedure changes the slot number of one
registered sensor.
Call page 3/3 from the [Sensor] menu.
Return to
Linkage menu
Tap the [Change slot] button
in the Sensor screen to call the
setup screen shown below.
Sensor slot change
1. Connect the sensor to the FX-36 as shown in
the gure above.
2. Tap
Change slot
Sensor screen.
3. Tap Read .
4. A sensor details screen appears.
5. The current start slot is displayed. To change
a start slot, a ＋
set to a slot that cannot be allocated like the
table of all pages.）
6. Tap to the Write .
on page 3/3 of the
button, tap.（Cannot be
This page is set when using multiple telemetry sensors
of the same type.
*For some transmitters (e.g., T6K), when the start slot of a
sensor is changed, the sensor cannot be used.
WARNING
Do not disconnect or turn transmitter
power OFF while telemetry sensor data
is being saved.
Sensor save data will be lost, resulting in
malfunction.
＜ Linkage menu ＞
*It is not necessary to carry out
multiple battery connections like
a T18M /T14SG.
93
Advertisement
Table of Contents
