FUTABA FX-36 Instruction Manual page 150

Acceleration
Acceleration setting can be performed at Elevator,
Elevator Camber and Aileron
only)
This setting is divided into elevator setting and camber
setting. The setting method is the same.
Camber setting sets the acceleration function for Ele
to camber mixing. Setting is not performed when Ele to
camber mixing is INH.
The acceleration function can be set for both the up
side and down side.
Function ON/OFF switch setting is performed for
Aileron Rudder setting only.
Aileron Rudder setting is acceleration
function setting for Aileron
performed when Aileron
Select [Acceleration] at the model
menu and call the setup screen shown
below.
W h e n u s i n g t h i s
function, Tap [INH].
(ON is displayed.)
Return to Model menu
The rate the angle
increases.
Setting method
Acceleration rate setting (Rate)
The return time after operation (Damping)
can be set.
T h e o p e r a t i o n p o i n t a t a c c e l e r a t i o n
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
150 ＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
[Corresponding model type]: Glider, general
Rudder. (Glider
Rudder mixing. It is not
Rudder mixing is INH.
C o n d i t i o n g r o u p /
single mode selection
(Gr. /Sngl)
The return time after operation (Damping)
can be set.
（First return）1 ∼ 100（Slow return）
（Acceleration doesn't function as 0.）
To next page
2/3 : Elevator → Camber
3/3 : Aileron → Rudder
Note: When using the acceleration function,
since the servo stroke is large, make your
settings so there is no binding of your linkage.
Operation up to this
range will initiate
acceleration.
Act position
Current position