Table of Contents
Advertisement
End point
The End point function adjusts the left and right
servo throws, generates differential throws, and
will correct improper linkage settings.
The travel rate (normal full stick movement at
high rates) can be varied from 30% to 140% in
each direction on channels 1 to 16. Also, the limit
point (how far the servo travels when a mix is
involved) where servo throw stops may be varied
from 0% to 155%.
Tap the [End point] button in the
Linkage menu to call the setup
screen shown below.
Return to
Linkage menu
Servo travel adjustment
1. Tap the travel button of the channel you
want to set. Value input buttons appear on
the screen.
2. se these buttons to adjust the rate.
Initial value: 100
Adjustment range: 30 ~140
3. Repeat the procedure above for each rate.
72
＜ Linkage menu ＞
Sets the travel, limit point.
I n d i c a t e s t h e c u r r e n t
direction of the stick, etc.
(The display screen is an example. The screen depends on the model type.)
Travel rate
Limit point
Left / Top
Right / Bottom
Limit point adjustment
1. Tap the limit button of the channel you want
to set.
2. se the value input buttons to adjust the limit
point.
Initial value: 135
Adjustment range: 0 ~155
3. Repeat this procedure for each limit point.
30 ∼
30 ∼
140%
140%
Next page
Ch7-16
Tap the values you
wish to adjust and
value input buttons
will appear on-screen.
Advertisement
Table of Contents
