Table of Contents
Advertisement
Trim mix 1/2
These functions call the ailerons, elevators, and
aps (camber aps, brake aps) trim offset rates
preset according to the ight state.
The amount of ailerons, elevator, and flaps
(camber ap, brake ap) trim offset can be set to
a switch.
As an example Trim mix 1 can be set up for
launching, with speed aps and ailerons dropped,
and a slight amount of up elevator. Trim mix
2 can be used for high speed flying, with both
ailerons and speed aps re exed slightly, and a bit
of down elevator.
The trim functions can be activated during
ight by setting a switch. To prevent sudden trim
changes when switching ight conditions, a delay
can be set to provide a smooth transition between
the two. Trim mix 2 will have priority over Trim
mix 1.
W h e n u s i n g t h i s
function, Tap [INH].
(ON is displayed.)
The ON/OFF switch of
mixing is chosen.
M a n u a l / A u t o m o d e
selection
Manual: Switches the
f u n c t i o n O N / O F F b y
switch
Auto: Trim mix function
call can be linked to a
stick, etc. A stick switch,
etc. separate from the
function ON/OFF switch
is set.
Condition delay setting
Return to Model menu
144
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
[Corresponding model type]: Glider, general
Select [Trim mix1 or 2] at the model
menu and call the setup screen
shown below.
Condition delay
cut switch
The offset rate of ailerons, flaps and elevators can be adjusted.
Tap to the corresponding setting item. Adjust the rate.
1. Move to the [INH] item
[ON].
*When separating the settings for each condition, move to
the [Group] item and set it to [Single].
2. Select the ON/OFF switch.
3. Select the [Manual] or [Auto] mode.
In the [Auto] mode, also select an auto SW. This
switch can be linked to a stick, etc.
Speed
In: The operation speed at switch ON can be set.
Out: The return speed at switch OFF can be set.
Fine Tuning
The offset rate can be varied in the Fine Tuning
numeric range set at screen by VR, etc. selection.
Condition Delay
When ight conditions are set, the operation speed
can be set for each condition. Condition delay
operation can be interrupted and each rudder
uickly returned to its original position by selecting a
cut switch.
*The display screen is an example. The actual
screen depends on the Model Type.
When a fine tuning VR is set,
the trim rates of ailerons,
flaps and elevators can be
adjusted.
Example
.
Set the trim mix function to
To next page
In speed
Out speed
（First） 0 ∼ 27 （ Slowly）
The value inside the
parentheses shows the
current rudder position.
Advertisement
Table of Contents
