Table of Contents
Advertisement
efore using the receiver be sure to read the
precautions listed in the following pages.
Connector
through 6 : outputs for the channels
through 6
/
: outputs of
/S
: outputs of
S.BUS Servo S.BUS yro
* hen using /S as S.
CH M D of the following page to mode
mode D.
S.
S2 : outputs of S.
S.BUS2 Servo S.BUS2 yro Telemetry Sensor
* hen using
or more channels use an S.
function or use a second R
both to your transmitter.
*CG
S.
S Gyro should
connected to the S.
Connector insertion
Firmly insert the connector in the direction
shown in the gure. Insert the S.
it
degrees.
Do not connect either a switch
Do not connect either a switch
or battery in this manner.
or battery in this manner.
channels and power.
channels or S.
S port.
S you have to set
S2 port.
S
and link
S2 ports on any receiver.
S2 by turning
DANGER
DANGER
DANGER
Don't attach a connector as shown in
the preceding illustration.
*It will short-circuit if connected in this way. A
short circuit across the battery terminals may
cause abnormal heating, fire and burns.
WARNING
S.BUS2 connectors
Don't connect an S.BUS servo / gyro
to S.BUS2 connector.
LED Monitor
This monitor is used to check the CH mode of
the receiver.
or
S
T be
Link/Mode Switch
se the small plastic screw driver that was
included with your receiver.
The ink/Mode Switch is also used for the CH
mode selection.
＋
Extra Voltage Connector
se this connector when using a voltage
telemetry device to send the battery voltage DC
ou will need to purchase the optional
xternal oltage input cable CA-R I -
ou can then make a cable with an extra
connector to the xternal voltage connector.
−
from the receiver to the transmitter.
＜ Before Use ＞
.
31
Advertisement
Table of Contents
