Table of Contents
Advertisement
Throttle cut
Throttle cut provides an easy way to stop the
engine, by ipping a switch with the throttle stick at
idle. The action is not functional at high throttle to
avoid accidental dead sticks. The switch's location
and direction must be chosen, as it defaults to " −
− " .
Tap the [Throttle cut] button in the Linkage menu to
call the setup screen shown below.
Return to
Linkage menu
This is the throttle cut
position. Tapping this
will display value input
buttons on-screen. Set
the engine stop position.
Throttle cut setting procedure
1. Tap the "INH" button.
2. Throttle cut function switch setting:
Tap the "--" button to call the
select screen, and then select the switch
and its ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual.)
3. Throttle cut position setting:
Tap the cut position button. Value input
buttons appear on the screen.
se these buttons to adjust the cut
position rate.
80
＜ Linkage menu ＞
Stops the engine safely and easily.
Tapping this will pull up the
hardware selection screen.
Select the throttle cut switch
and ON-OFF direction.
Hardware
Tapping this will change
INH to either OFF or ON
and activated.
This indicates the throttle stick's current
position. Throttle cut will only function
when the throttle stick is more than 1/3rd
into the slow throttle range.
Initial value: 17
Adjustment range: （LOW）0 ~50 （Middle）
*With throttle stick at idle, adjust the rate until the engine
consistently shuts off.
To exit the setting, tap the [Throttle cut]
button.
The yellow line is the
cut position. When
the cut switch is ON,
the throttle will move
to this position.
Advertisement
Table of Contents
