Table of Contents
Advertisement
The various functions used in the FX-36 can be selected by switch. The switch (including when stick,
trim lever, or VR are used as a switch) setting method is common to all functions.
Switch selection
When a switch is selected at a mixing function, etc., the selection screen shown below is called.
When switch is selected
Switch ON/OFF setting is possible at each
position.
1. When the ON/OFF "Set" position switch is
tapped after the switch was selected, the
screen shown below appears.
Normal or Alternate: Alternate switching
mode is available depending on mixing
function.
*When the button of each position is tapped,
it toggles between ON and OFF.
2. Tap the button and set to the ON position.
3. Close the screen by tapping [Hardware
select].
(Switch selection screen example)
When stick, trim lever, or VR is selected.
switch, the following 4 modes can be selected.
When a stick, trim lever, or VR is used as a
Next page
Tap the chosen
switch.
＜ Data ＞
177
Advertisement
Table of Contents
