Table of Contents
Advertisement
Air brake
This function is used when an air brake is
necessary when landing or diving, etc.
The preset elevators and flaps (camber flap,
brake flap) offset amount can be activated by a
switch.
The offset amount of the aileron, elevator, and
flap servos can be adjusted as needed. Also the
speed of the aileron, elevator, and ap servos can
be adjusted. (In side/Out side) A delay can be set
for each condition, and a Cut switch which will
turn OFF the delay can be chosen. Trim amounts
can be fine-tuned by setting a VR. You can also
set the Auto Mode, which will link Airbrake to a
stick, switch, or dial. A separate stick switch or
dial can also be set as the ON/OFF switch.
Select [Air brake] at the model menu and call the
setup screen shown below.
W h e n u s i n g t h i s
function, Tap [INH].
(ON is displayed.)
The ON/OFF switch of
air brake is chosen.
M a n u a l / A u t o m o d e
selection
Manual: Switches the
f u n c t i o n O N / O F F b y
switch
Auto: Air brake function
call can be linked to a
stick, etc. A stick switch,
etc. separate from the
function ON/OFF switch
is set.
Return to Model menu
The value inside the
parentheses shows the
current rudder position.
146
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
C o n d i t i o n d e l a y
setting and cut switch
setting.
Aileron 2
*The display screen is an example. The actual
screen depends on the Model Type.
To next page
Fine tuning setting
Elevator
Aileron 1
In speed
Out speed
（First） 0 ∼ 27 （ Slowly）
O f f s e t ： T h e o f f s e t
rate of ailerons, flaps,
and elevators can be
a d j u s t e d . Ta p t o t h e
corresponding setting
item. Adjust the rate.
Fine tuning：When a fine
tuning VR is set on the
next page, the ailerons',
flaps', and elevators' trim
rates can be adjusted.
Tap to the corresponding
setting item. Adjust the
rate.
Advertisement
Table of Contents
