Table of Contents
Advertisement
3. Select the operating mode for each channel.
"NORM": The model is controlled by signals
from the student transmitter.
"MIX" mode: The model is controlled by
s i g n a l s f r o m t h e t e a c h e r a n d s t u d e n t
transmitters. (Reset the student s model data
to the default condition.)
"F NC" mode (function mode):
The model is controlled by signals from
the student transmitter with the teacher
AFR setting. (Reset the student s model data
to the default condition.)
"OFF": Only the teacher side operates.
*The setting above allows setting of the servo throw relative
to the amount of student side operation when [MIX] or
[FUNC] was selected.
When changing the rate, use the "
" " "
" button to Tap the [Rate] item of
the channel.
Setting range: -100~+100
Initial value: +100
*When the value is tapped, the rate is reset to the initial value.
4. Set the switch of each channel.
*When setting the switch at each channel, tap to the "SW"
item of the channel you want to change, call the switch
setup screen, and select the switch.
"--" : Always ON.
"SA"~"SH": The switch which enables student
side operation can be selected. (See "Switch
selection method" at the end of this manual
for selection method details.)
116
＜ Linkage menu ＞
Trainer student channel setting function
In training mode, the instructor's transmitter can
pick up the student's signal on both the "Function"
and "Mix" channels. That makes it easy for the
two transmitters to connect even if the student and
instructor have set up their transmitters differently.
*When the instructor's transmitter mode is set to "NORM",
the signal of the same channel of the student's transmitter is
output as is. (The same as before.)
" " "
Advertisement
Table of Contents
