Table of Contents
Advertisement
Telemetry : Altitude
Altitude is a screen which displays / sets up the altitude
information from an optional altitude sensor or GPS sensor.
The altitude of the model which is ying can be known. If it
becomes higher (low) than preset altitude, you can be told by
alarm. Warning by vibration can also be chosen. Data when
a power supply is turned on shall be 0 m, and it displays the
altitude which changed from there. Even if the altitude of an
air eld is high, that shall be 0 m and the altitude difference
from an airfield is displayed. This sensor calculates the
Tap the [Altitude] button in the Telemetry screen to
call the setup screen shown below.
Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
indicates the alarm
will sound when the
altitude reaches above
your set value.
↓ A downward arrow
indicates the alarm
will sound when the
altitude reaches below
your set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
First, the set of a reference is required.
1. The model and transmitter to which the
altitude sensor was connected are turned on.
2. Tap to the [Preset] of "Reference" item.
*Atmospheric pressure is changed according to the weather
also at the same air eld. You should preset before a ight.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
*An altitude sensor or GPS sensor must be installed in the aircraft.
Allows Melody to be
turned ON or OFF.
Displaying data from the altitude
altitude from atmospheric pressure. Atmospheric pressure
will get lower as you go up in altitude. Using this, the
sensor will estimate the altitude. Please understand that an
exact advanced display cannot be performed if atmospheric
pressure changes in a weather situation.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
Sets the altitude
on which the alarm
operates.
Alarm set : Altitude
1. Tap Alarm and choose from Bu er, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if not using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [xxx m] item .
4. Adjust the rate using the "
buttons.
Initial value: 200m -50m
Adjustment range -500m~+3,000m
( Limit ≧ Limit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the H/E button.
＜ Linkage menu ＞
Altitude
● If this is set to Mode1-4,
a rise and dive are told
by a different melody.
Mode1: Little rise/dive
→ Melody changes
: sensitively
Mode4: Big rise/dive
→ Melody changes
: insensible
" " " " " "
99
"
Advertisement
Table of Contents
