Table of Contents
Advertisement
Data reset
This function is designed to allow you to reset
selected portions or all of the settings saved in
the active model memory. You may individually
choose to reset the following sets of data:
Trim (All condition):
Reset the digital trim setting.
*All the conditions, or the condition currently being displayed
(the entire group for group setting), can be selected.
*The trim step amount and trim rate are not reset.
Trim (Current and Group condition):
Reset the digital trim setting.
*Current condition, group condition, can be selected.
*The trim step amount and trim rate are not reset.
Select [Data reset] at the linkage menu and call
the setup screen shown below.
Return to Linkage menu
Data resetting method
1. Tap to the item you want to reset and tap
the screen.
*A con rmation message appears.
2. Execute reset by tapping the "Yes".
CAUTION
Never engage the Data reset function
while the engine is starting or the
motor drive wiring is connected.
■ Sudden, abrupt spinning of propellers or rotors
is extremely dangerous.
Model memory setting data reset. (by item)
Model menu setting:
Resets all the functions in the Model menu
except condition select.
All model setting:
Resets all Linkage and Model menu functions
except for frequency, model select, and model type.
Function Name:
A function name is reset.
Telemetry:
Reset the telemetry setting.
[Trim (All condition)]: Resets only the Trim (all
conditions)
[Trim(Current and Group condition)]: Resets
only the data of Trim (condition in use and all
the conditions set to group mode)
[Model menu setting]: Resets all the functions
in the model menu, except the condition
selection functions.
[All model setting]: Resets all the functions in
the linkage menu and model menu except
the fre uency, model select, and model
type functions.
[Function name]: Resets only the function
name functions.
[Telemetry]: Resets only the teremetry
functions.
CAUTION
Throttle Reverse
■ Only the throttle channel (CH3) initial setting is
REV (reverse). Thoroughly check the Hi and Low
directions of the engine or motor used and be
careful that they do not suddenly run at full
speed. Even after data reset, CH3 is reversed.
＜ Linkage menu ＞
119
Advertisement
Table of Contents
