Table of Contents
Advertisement
Sensor：Reload
When using multiple sensors of the same type
the sensors must be registered in the transmitter.
Connect all the sensors to be used to the FX-36 as
shown in the gure at the right and register them by
the following procedure. The ID of each sensor is
registered in the transmitter.
Call page 3/3 from the [Sensor] menu.
Return to
Linkage menu
Reading all the sensors to be used
1. Connect the sensor to the FX-36 as shown in the gure above.
2. Tap Reload on page 3/3 of the [Sensor] screen.
3. Tap Reload .
All the sensors are registered and can be used.
Sensor : Register
This function registers an additional sensor.
Connect the sensor as shown in the figure at the
right and register it by the following procedure.
The sensor ID is registered in the transmitter.
Call page 3/3 from the [Sensor] menu.
Return to
Linkage menu
Additional sensor registration
1. Connect the sensor to the FX-36 as shown in the figure
above.
2. Tap Register on page 3/3 of the Sensor screen.
3. The sensor is registered and can be used.
92
＜ Linkage menu ＞
This page is set when using multiple telemetry sensors of the same type.
This page is set when using multiple telemetry sensors of the same type.
Hub
Hub
*It is not necessary to carry out
multiple battery connections like
a T18M /T14SG.
*It is not necessary to carry out
multiple battery connections like
a T18M /T14SG.
*When the number of slots needed in
registration is insufficient, an error is
displayed and registration cannot be
performed. Disable unused slots or
perform the following reload.
Hub
Advertisement
Table of Contents
