Table of Contents
Advertisement
Curve setting examples
The curves shown below are created by using
the point curve type and inputting the data of the
5 points 0% (low side), 25%, 50% (center), 75%,
100% (high) side at each condition. They are
ro le Curve
Normal Curve
The Throttle Hover trim setup screen can be called from the Throttle curve setup screen.
Return to Model menu
The Throttle Hover function trims the throttle
near the hovering point. Normally, use it with
hovering conditions. Changes in rotor speed
accompanying changes in the temperature,
humidity, and other flight conditions can be
trimmed. Adjust the throttle so that rotor rotation is
most stable. More delicate trimming is also possible
by using this function along with the Hover Pitch
function.
Setting method
When using the hovering (normal) condition
only, switch the group mode to the single
mode (initial setting) and make the settings.
Tap [INH]. (ON is displayed.)
ample
Idle-up 1 Curve
created by reducing the number of points on the
line to 5. When actually creating a curve, enter
the data speci ed per the aircraft (or the reference
value).
*For a description of the curve creation method, see the
description at the back of this manual.
Idle-up 2 Curve
Throttle servo speed setting
(For a description of the setting method, see the
description at the back of this manual.)
Select the adjustment knob.
Selection example: RD
The trim operation mode (Mode: Center/
Normal) can be selected.
Center mode: Maximum rate of change
n e a r c e n t e r b y c e n t e r t r i m o p e r a t i o n
(recommended)
Normal mode: Normal trim (horizontal
movement trim) operation.
Trim adjustment range (Range) setting
When the value is made small, trim acts only
near the center.
The trim rate can be adjusted and the
operation direction can be set.
＜ Model Menu (Helicopter Functions) ＞
159
Advertisement
Table of Contents
