Table of Contents
Advertisement
Servo Reverse
Servo Reverse changes the direction of an
individual servo's response to a control stick
movement.
For CCPM helicopters, be sure to read the
section on Swash AFR before reversing any servos.
With CCPM helicopters, always complete your
servo reversing prior to any other programming.
If you use pre-built Airplane/Glider functions that
control multiple servos, it may be confusing to
tell whether the servo needs to be reversed or a
setting in the function needs to be reversed. See the
instructions for each specialized function for further
details. Always check servo direction prior to every
Tap the [Servo reverse] button in the Linkage
menu to call the setup screen shown below.
Return to Linkage menu
(The display screen is an example. The screen depends on the model type.)
Servo reversing procedure
After setting up a new model, be sure to
define all special menus. Be sure that all servos
are plugged into the proper receiver channels.
Now, determine whether you need to reverse any
channels by moving each stick and observing the
corresponding movement in the model's controls.
se to reverse the servo throw direction.
ight as an additional precaution to con rm proper
model memory, hook ups, and radio function.
WARNING
Before a flight, always check that your
model's servo operation, the direction
of control surfaces, and switch setup
are correct.
Default setting of the throttle/motor
channel is always reverse.
1. Tap the desired channel s setting button to
choose the proper direction for the servo.
2. Tap Yes in the next screen.
3. Repeat for each servo needing reversal.
When done, tap Servo reverse to return to
the Linkage menu.
＜ Linkage menu ＞
Tap the channel you
wish to reverse.
Tap the Yes
→ Reverse
71
Advertisement
Table of Contents
