Table of Contents
Advertisement
Telemetry: Receiver [Ext. battery]
The EXT-VOLT screen will display the data from
the EXT-battery output from the R7008SB receiver.
In order to use this function, it is necessary to
connect external voltage connector of the R7008SB
receiver to a CA-RVIN-700 or SBS-01V to the
battery you desire to measure the voltage of the
EXT-battery.
Tap the [Receiver] button in the Telemetry screen
to call the setup screen shown below.
Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↓ The "down" arrow
will indicate that an
alarm will sound when
the voltage drops to
below the setting.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
Alarm set
1. Tap Alarm and choose from Bu er, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if not using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [4.0V] item.
4. Adjust the rate using the "
buttons.
Initial value: 4.0V
Adjustment range: 0.0V~100.0V
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the H/E button.
96
＜ Linkage menu ＞
*CA-RVIN-700 must be installed in the aircraft.
the voltage set by you is exceeded.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
*The FASSTest18CH /T-FHSS mode can use all the telemetry
" " " " " "
"
Displaying data from the EXT
battery voltage port
You will be alerted by an alarm or vibration if
FASSTest12CH mode.
functions.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
Ext. battery
voltage
Sets the voltage on
w h i c h t h e a l a r m
operates.
Advertisement
Table of Contents
