Table of Contents
Advertisement
Gyro [Helicopter]
This function is used to adjust gyro sensitivity.
The sensitivity and operation mode (Normal mode/
AVCS mode) can be set for each condition.
The gyro sensitivity can be switched with each
condition or the switch. (3 sensitivities)
*Compatible with 3 axis gyro (CGY750).
Select [Gyro] at the
model menu and call
the setup screen.
Return to Model menu
The operation mode
( A V C S / N O R ) a n d
sensitivity of the 3
a x e s G y r o / G y r o 2 /
Gyro3 can be set.
Use this when you want
to adjust sensitivity via
VR, etc., and not on-
screen data entry. Tap "--
", select "VR", etc., and
then tap the value to
adjust. (Won't operate
when value is "0".)
Setting method
When using this function, Tap [INH]. (ON is
displayed.)
When you want to set the same contents at
other conditions, select the group mode.
When you want to set the selected condition
only, select the single mode (initial setting).
Three rates can be switched for each
condition. (Rate1/Rate2/Rate3)
A ne tuning VR can be set.
166
＜ Model Menu (Helicopter Functions) ＞
Gyro（RUD)
Gyro2（AIL)
setting
setting
When using Rate2/Rate3, make it
INH → ON or OFF.
Note: [Gyro] [Gyro2] [Gyro3] Default function
[Gyro]: CH6(FASSTest12CH) CH5(Other system type)
[Gyro2] : CH9
[Gyro3] : CH10
Always set to [--] both (control) and (trim) for
the [Gyro] function at the Function menu in
the Linkage menu.
Gyro3（ELE)
setting
Tapping these will
pull up the detailed
selection screen for
each.
Rate1 Gyro type and
gain
Rate2 Gyro type and
gain
Rate3 Gyro type and
gain
C o n d i t i o n g r o u p /
single mode selection
(Gr. /Sngl)
The ON/OFF switch
of gyro is chosen.
3 rate (gyro gain)
adjustment
Advertisement
Table of Contents
