Table of Contents
Advertisement
7. When the software update is completed,
"Completed" message is shown on the LCD
display of your FX-36. (Show below picture.)
Complete
8. Turn off the power switch of your FX-36 and
remove the SD card from the card slot.
Possible Problems
When one of the error messages shown
below appears on the LCD screen your
FX-36, the software update will not be
completed.
"Low battery."
Software update is postponed because
of low battery. Retry the software update
after the battery is recharged.
The FX-36 cannot nd the update le on the
SD card. Check to be sure all the update
les have been copied onto the SD card.
The FX-36 detects the update le error. The
update file may be broken or for another
transmitter.
"Write error."
The software update procedure is stopped
for an unknown reason. Contact your local
service center when this error message
appears on the LCD screen of your FX-36.
＜ Data ＞
182
There is a possibility that the transmitter
will be damaged.
Recovering a failed update
If you failed to update for any reason, it
may transmitter will not start.
In that case, please update again
transmitter in the following procedure.
1. Detach the battery from the transmitter.
2. Insert the SD card that contained the
update les to the transmitter.
3. Attach the battery to the transmitter
while pressing down the "H/E" button.
4. The update will start.
E v e n a f t e r t h e a b o v e s t e p s , i f t h e
transmitter fails to update or does not
start, please have it serviced.
Initiali ation of nal means
Note: In the unlikely event that model data
is damaged and can not be set, the
current model data can be initialized by
the following method.
Note: Do not use it except when data is
corrupted.
1. Turn off the power of the transmitter.
2. Hold the H/E button and the U/M Button
at the same time, turn on the transmitter
power.
3. An initialization warning screen appears.
4. Touch Yes to initialize and turn off the
power. Since the current model data is
initialized, please reconfigure from the
beginning and check the operation
suf ciently.
Advertisement
Table of Contents
