Table of Contents
Advertisement
Gyro
This function is used when a GYA Series gyro
is used to stabilize the aircraft's attitude. The
sensitivity and operation mode (Normal mode/GY
mode) can be switched with a switch.
Three rates (Rate1/Rate2/Rate3) can be switched.
U p t o 3 a x e s ( G y r o / G y r o 2 / G y r o 3 ) c a n b e
simultaneously controlled.
*Initial setting does not assign a sensitivity channel. Use the
Select [Gyro] at the model menu and
call the setup screen shown below.
Return to Model menu
The operation mode
( A V C S / N O R ) a n d
sensitivity of the 3
a x e s G y r o / G y r o 2 /
Gyro3 can be set.
Three rates (Rate1/Rate2/Rate3) can be used.
Tap to the [Rate] item. Adjust the rate.
When using this function, Tap [INH].
When a Futaba GYA gyro is used, when [GY] type is selected, the
sensitivity set value is directly read in both the AVCS and Normal modes.
When setting a switch, tap the Switch item and tap the "--" button to call
the selection screen, and then select the switch and set its ON direction.
(For a description of the switch selection method, see the description at
the end of this manual.)
[Corresponding model type]: Airplane/glider/multicopter, general
Tapping this will change INH to either ON or OFF
and enable operation. Adjustment of the three
rates (sensitivity) and switching between Normal
and AVCS is possible.
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
Function menu of the Linkage menu to assign the sensitivity
channel (Gyro/Gyro2/Gyro3) used to a vacant channel
beforehand.
Set [Control] and [Trim] other than Function to [--].
C o n d i t i o n g r o u p /
single mode selection
(Gr. /Sngl)
The ON/OFF switch of
gyro is chosen.
3 rate (gyro gain)
adjustment
147
Advertisement
Table of Contents
