Table of Contents
Advertisement
Telemetry : GPS [Distance]
The Distance screen displays and sets altitude
data from an SBS-01/02G GPS Sensor (sold
separately), and allows the distance to the airborne
aircraft to be read by the transmitter. When the
aircraft flies inside or outside the set distance, an
alarm and vibration alerts the pilot.
Tap the [GPS] button in the Telemetry screen to call
the setup screen shown below.
Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
indicates the alarm
will sound when the
d i s t a n c e r e a c h e s
above your set value.
↓ A downward arrow
indicates the alarm
will sound when the
d i s t a n c e r e a c h e s
below your set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
*A GPS sensor must be installed in the aircraft.
Tap to the [Preset] of "Reference"
item. Sets the current aircraft position
as the starting point.
Displaying data from the Distance Screen
*The GPS sensor is necessary, and is sold separately. Mount
and connect the sensor in accordance with the sensor
instruction manual.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
Altitude calculated as either straight line distance
(slant) or surface distance on a map can also be
selected.
Surface
Select <Slant> <Surface> to "Distance mode", tap the
screen.
＜ Linkage menu ＞
Distance
S e t s t h e d i s t a n c e
on which the alarm
operates.
Altitude
105
Advertisement
Table of Contents
