Agilent 1100 Series Interfaces - Agilent Technologies 1100 Series Reference Manual

The following cards can be used with the Agilent 1100 modules.
Table 47
Minimum firmware of the JetDirect cards is A.05.05.
NOTE
Recommended Cables
For point to point connection (not using a network hub) use a twisted pair cross over
LAN cable (P/N 5183-4649, 10 feet long).
For standard network connections using a hub use category 5 UTP cables, ( P/N G1530-
61480, 8 m long ).

Agilent 1100 Series Interfaces

The Agilent 1100 Series modules provide the following interfaces :
Table 48 Agilent 1100 Series Interfaces
Interface Type Pumps
CAN Yes
GPIB Yes
RS-232C Yes
1100 Series Variable Wavelength Detector Reference Manual 195
LAN Boards
Agilent Order Number
J4106A
J4105A
J4100A
Autosample
r
Yes
Yes
Yes
Introduction to the Variable Wavelength Dector
Supported networks
Ethernet/802.3, RJ-45 (10Base-T(
Token Ring/802.5, DB9, RJ-45 (10Base-T)
Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX) + BNC
(10 Base 2)
DA Detector VW Detector
MW Detector RI Detector
FL Detector
Yes Yes
Yes Yes
Yes Yes
Thermostatted Vacuum
Column Degasser
Compartment
Yes No
Yes No
Yes No
6