Agilent Technologies 1100 Series Reference Manual page 21

7 Connect the analog cable (optional).
If a Agilent 1100 DAD/MWD is in the system, the LAN/GPIB should be connected to the
NOTE
DAD/MWD (due to higher data load).
8 Connect the APG remote cable (optional) for non-Agilent 1100 Series instruments.
9 Turn on power by pushing the button at the lower left-hand side of the detector. The
Figure 4 Rear View of Detector
The detector is turned on when the line power switch is pressed and the green indicator lamp is illuminated.
The detector is turned off when the line power switch is protruding and the green light is off.
1100 Series Variable Wavelength Detector Reference Manual 19
•
the GPIB cable to the detector or
•
the LAN connection to the LAN interface board in the detector.
status LED should be green.
Installing the Variable Wavelength Detector
1