Agilent Technologies 1100 Series Reference Manual page 20

1
Installing the Variable Wavelength Detector
Parts required
1 Install the LAN interface board in the detector (if required), see
2 Place the detector in the stack or on the bench in a horizontal position.
3 Ensure the line power switch at the front of the detector is OFF.
with green light
Figure 3 Front View of Detector
The figure above shows the flow cell already installed. The flow cell area is closed with
NOTE
a metal cover. The flow cell has to be installed as described in
the Detector"
4 Connect the power cable to the power connector at the rear of the detector.
5 Connect the CAN cable to other Agilent 1100 Series modules.
6 If a Agilent ChemStation is the controller, connect either
18 1100 Series Variable Wavelength Detector Reference Manual
Unpack the detector.
Detector
Power cord, for other cables see text below and
160 ChemStation and/or Control Module G1323A/B
Interface Board" on page 134.
on page 22.
"Cable Overview" on page
"Replacing the
"Flow Connections to