Agilent Technologies 1100 Series Reference Manual page 215

Status
This is an example if an Agilent 1100 VWD is configured standalone. Information on
the actual wavelength setting, absorbance value, elapsed run time, messages and the
signal plot are shown. Press key F8 (Start) to start a run, key F7 (Rescale) to
maximize the signal.
Signal plot
Press F6 key (Plot) to enter the plot screen (available also from the Analysis and System
screen). Here you can observe the online signal(s). To add additional online signals
(maximum 3), press F6 key (Select). If more than one signal is configured (see next), use
the 1-2-3 number key to switch between the signals.
Press F6 key (Select). Here you can add additional online signals (maximum are 3),
press F6 key (Select). Additional signals could be also pressure or temperature signals
from other modules. Use the Right/Left arrows to switch between Available and
1100 Series Variable Wavelength Detector Reference Manual 213
Control Module Screens for the Agilent 1100 Variable Wavelength Detector
7