Dell Force10 Z9000 Configuration Manual page 205

Table 11. Additional Default CAM Allocation Settings
Additional CAM Allocation
FCoE ACL (fcoeacl)
ISCSI Opt ACL (iscsioptacl)
The ipv6acl and vman-dual-qos allocations must be entered as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use
either even or odd numbered ranges.
You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the
new settings to take effect.
CAM Allocation for Ingress
Use the cam-acl-egress command to allocate the space for egress L2, IPV4 and IPV6 ACL. The total number of available FP blocks is
4. Allocate atleast one group of L2ACL and IPV4 ACL.
Dell(conf)#do show cam-acl-egress
-- Chassis Egress Cam ACL --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
-- Stack unit 7 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Dell(conf)#
1. Select a cam-acl action.
CONFIGURATION mode
cam-acl [default | l2acl]
NOTE: Selecting default resets the CAM entries to the default settings. Select l2acl to allocate the desired space
for all other regions.
2. Enter the number of FP blocks for each region.
EXEC Privilege mode
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos
number l2pt number ipmacacl number vman-qos | vman-dual-qos number ecfmacl number
nlbcluster number ipv4pbr number openflow number | fcoe number iscsioptacl number
NOTE: If the allocation values are not entered for the CAM regions, the value is 0.
3. Execute the write memory, verify that the new settings will be written to the CAM on the next boot.
EXEC Privilege mode
show cam-acl
4. Reload the system.
1 block = 256 entries
1
1
2
1
1
2
1
1
2
Setting
0
0
Content Addressable Memory (CAM)
205