Enabling Spanning Tree Protocol Globally - Dell Force10 Z9000 Configuration Manual

Example of the show config Command
To verify that an interface is in Layer 2 mode and enabled, use the show config command from INTERFACE mode.
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
Dell(conf-if-te-1/1)#

Enabling Spanning Tree Protocol Globally

Enable the spanning tree protocol globally; it is not enabled by default.
When you enable STP, all physical, VLAN, and port-channel interfaces that are enabled and in Layer 2 mode are automatically part of
the Spanning Tree topology.
• Only one path from any bridge to any other bridge participating in STP is enabled.
• Bridges block a redundant path by disabling one of the link ports.
Figure 107. Spanning Tree Enabled Globally
To enable STP globally, use the following commands.
1. Enter PROTOCOL SPANNING TREE mode.
CONFIGURATION mode
protocol spanning-tree 0
2. Enable STP.
PROTOCOL SPANNING TREE mode
Spanning Tree Protocol (STP)
713