Dell Force10 Z9000 Configuration Manual page 657

The following output displays the modes available for the role command.
Dell (conf)#role ?
configure
exec
interface
line
route-map
router
Examples: Deny Network Administrator from Using the show users Command.
The following example denies the netadmin role from using the show users command and then verifies that netadmin cannot
access the show users command in exec mode. Note that the netadmin role is not listed in the Role access:
secadmin,sysadmin, which means the netadmin cannot access the show users command.
Dell(conf)#role exec deleterole netadmin show users
Dell#show role mode exec show users
Role access: secadmin,sysadmin
Example: Allow Security Administrator to Configure Spanning Tree
The following example allows the security administrator (secadmin) to configure the spanning tree protocol. Note command is
protocol spanning-tree.
Dell(conf)#role configure addrole secadmin protocol spanning-tree
Example: Allow Security Administrator to Access Interface Mode
The following example allows the security administrator (secadmin) to access Interface mode.
Dell(conf)#role configure addrole secadmin ?
LINE Initial keywords of the command to modify
Dell(conf)#role configure addrole secadmin interface
Example: Allow Security Administrator to Access Only 10-Gigabit Ethernet Interfaces
The following example allows the security administrator (secadmin) to only access 10-Gigabit Ethernett interfaces and then shows
that the secadmin, highlighted in bold, can now access Interface mode. However, the secadmin can only access 10-Gigabit
Ethernet interfaces.
Dell(conf)#role configure addrole secadmin ?
LINE Initial keywords of the command to modify
Dell(conf)#role configure addrole secadmin interface tengigabitethernet
Dell(conf)#show role mode configure interface
Role access: netadmin, secadmin, sysadmin
Example: Verify that the Security Administrator Can Access Interface Mode
The following example shows that the secadmin role can now access Interface mode (highlighted in bold).
Role Inheritance
netoperator
netadmin
secadmin
sysadmin
Example: Remove Security Administrator Access to Line Mode.
Global configuration mode
Exec Mode
Interface configuration mode
Line Configuration mode
Route map configuration mode
Router configuration mode
Modes
Exec Config Interface Router IP RouteMap Protocol MAC
Exec Config Interface Line
Exec Config Interface Line Router IP RouteMap Protocol MAC
657
Security