Dell Force10 Z9000 Configuration Manual page 607

ROUTER RIP mode
distribute-list prefix-list-name in
• Assign a configured prefix list to all outgoing RIP routes.
ROUTER RIP mode
distribute-list prefix-list-name out
To view the current RIP configuration, use the show running-config command in EXEC mode or the show config
command in ROUTER RIP mode.
Adding RIP Routes from Other Instances
In addition to filtering routes, you can add routes from other routing instances or protocols to the RIP process.
With the redistribute command, you can include open shortest path first (OSPF), static, or directly connected routes in the
RIP process.
To add routes from other routing instances or protocols, use the following commands.
• Include directly connected or user-configured (static) routes in RIP.
ROUTER RIP mode
redistribute {connected | static} [metric metric-value] [route-map map-name]
– metric-value: the range is from 0 to 16.
– map-name: the name of a configured route map.
• Include specific OSPF routes in RIP.
ROUTER RIP mode
redistribute ospf process-id [match external {1 | 2} | match internal] [metric value]
[route-map map-name]
Configure the following parameters:
– process-id: the range is from 1 to 65535.
– metric: the range is from 0 to 16.
– map-name: the name of a configured route map.
To view the current RIP configuration, use the show running-config command in EXEC mode or the show config
command in ROUTER RIP mode.
Setting the Send and Receive Version
To change the RIP version globally or on an interface in Dell Networking OS, use the following command.
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive only one or the other
version, use the ip rip send version or the ip rip receive version commands in INTERFACE mode.
You can set one RIP version globally on the system using system. This command sets the RIP version for RIP traffic on the
interfaces participating in RIP unless the interface was specifically configured for a specific RIP version.
• Set the RIP version sent and received on the system.
ROUTER RIP mode
version {1 | 2}
• Set the RIP versions received on that interface.
INTERFACE mode
ip rip receive version [1] [2]
• Set the RIP versions sent out on that interface.
INTERFACE mode
Routing Information Protocol (RIP)
607