Dell Force10 Z9000 Configuration Manual page 528

In this example, the list "xyz" is applied to the tenGigabitEthernet 2/1 interface.
Applying a Redirect-list to an Interface Example:
Dell(conf-if-te-2/1)#ip redirect-group xyz
Dell(conf-if-te-2/1)#
Applying a Redirect-list to an Interface Example:
Dell(conf-if-te-1/1)#ip redirect-group test
Dell(conf-if-te-1/1)#ip redirect-group xyz
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/2)#
Dell(conf-if-gi-1/1)#ip redirect-group test
Dell(conf-if-gi-1/1)#ip redirect-group xyz
Dell(conf-if-gi-1/1)#show config
!
interface GigabitEthernet 1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/2)#
In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are supported on a single interface. Dell
Networking OS has the capability to support multiple groups on an interface for backup purposes.
Show Redirect List Configuration
To view the configuration redirect list configuration, use the following command in EXEC mode:
Command Syntax
show ip redirect-list redirect-list-name
show cam pbr
show cam-usage
List the redirect list configuration using the show ip redirect-list redirect-list-name command. The non-contiguous mask is
displayed in dotted format (x.x.x.x). The contiguous mask is displayed in /x format. Some sample outputs are shown below:
Dell#show ip redirect-list explicit_tunnel
IP redirect-list explicit_tunnel:
Defined as:
seq 5 redirect tunnel 1 track 1 tcp 155.55.2.0/24 222.22.2.0/24, Track 1 [up], Next-hop
reachable (via Te 1/32)
seq 10 redirect tunnel 1 track 1 tcp any any, Track 1 [up], Next-hop reachable (via Te 1/32)
528
Policy-based Routing (PBR)
redirect-list-name is the name of a redirect list to apply
to this interface.
FORMAT: up to 16 characters
Delete the redirect list from this interface with the [no] ip redirect-group
command.
Command Mode
EXEC
EXEC
Purpose
View the redirect list configuration and the
associated interfaces.
View the redirect list entries programmed in the
CAM.