Moving Untagged Interfaces - Dell Force10 Z9000 Configuration Manual

Hide thumbs Also See for Force10 Z9000:
Table of Contents

Advertisement

NUM Status
Q
Ports
* 1
Inactive
2
Active
T
Po1(So 0/0-1)
T
Te 1/1
3
Active
T
Po1(So 0/0-1)
T
Te 1/2
4
Active
T
Po1(So 0/0-1)
When you remove a tagged interface from a VLAN (using the no tagged interface command), it remains tagged only if it is a
tagged interface in another VLAN. If the tagged interface is removed from the only VLAN to which it belongs, the interface is placed
in the Default VLAN as an untagged interface.

Moving Untagged Interfaces

To move untagged interfaces from the Default VLAN to another VLAN, use the following commands.
1.
Access INTERFACE VLAN mode of the VLAN to which you want to assign the interface.
CONFIGURATION mode
interface vlan vlan-id
2.
Configure an interface as untagged.
INTERFACE mode
untagged interface
This command is available only in VLAN interfaces.
Move an Untagged Interface to Another VLAN
The no untagged interface command removes the untagged interface from a port-based VLAN and places the interface in
the Default VLAN. You cannot use the no untagged interface command in the Default VLAN. The following example shows
the steps and commands to move an untagged interface from the Default VLAN to another VLAN.
To determine interface status, use the show vlan command. Interface (gi 3/2) is untagged and in the Default VLAN (vlan 1). In a
port-based VLAN (vlan 4), use the untagged command to add the interface to that VLAN. The show vlan command output
displays the interface's changed status (gi 3/2). Because the Default VLAN no longer contains any interfaces, it is listed as inactive.
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM
Status
Q
Ports
* 1
Active
U
Te 1/2
2
Active
T
Po1(So 0/0-1)
T
Te 1/3
3
Active
T
Po1(So 0/0-1)
T
Te 1/1
4
Inactive
Dell#conf
Dell(conf)#interface vlan 4
Dell(conf-if-vlan)#untagged tengigabitethernet 1/2
Dell(conf-if-vlan)#show config
!
interface Vlan 4
no ip address
untagged TenGigabitEthernet 1/2
Dell(conf-if-vlan)#end
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM
Status
Q
742
Virtual LANs (VLANs)
Ports

Advertisement

Table of Contents
loading

Table of Contents