Dell Force10 Z9000 Configuration Manual page 608

ip rip send version [1] [2]
Examples of the RIP Process
To see whether the version command is configured, use the show config command in ROUTER RIP mode.
The following example shows the RIP configuration after the ROUTER RIP mode version command is set to RIPv2. When you
set the ROUTER RIP mode version command, the interface (TenGigabitEthernet 1/1) participating in the RIP process
is also set to send and receive RIPv2 (shown in bold).
To view the routing protocols configuration, use the show ip protocols command in EXEC mode.
Dell#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 23
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface
TenGigabitEthernet
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance
Distance: (default is 120)
Dell#
To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The command syntax for
sending both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following example.
Dell(conf-if)#ip rip send version 1 2
Dell(conf-if)#ip rip receive version 2
The following example of the show ip protocols command confirms that both versions are sent out that interface. This
interface no longer sends and receives the same RIP versions as Dell Networking OS does globally (shown in bold).
Dell#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 11
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface
TenGigabitEthernet 1/1
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance
Distance: (default is 120)
Dell#
608
Routing Information Protocol (RIP)
Recv Send
1/1 2 2
Last Update
Recv Send
2 1 2
Last Update