As Number Migration - Dell Force10 Z9000 Configuration Manual

Dell(conf-router_bgp)#do show ip bgp
BGP table version is 28093, local router ID is 172.30.1.57

AS Number Migration

With this feature you can transparently change the AS number of an entire BGP network and ensure that the routes are propagated
throughout the network while the migration is in progress.
When migrating one AS to another, perhaps combining ASs, an eBGP network may lose its routing to an iBGP if the ASN changes.
Migration can be difficult as all the iBGP and eBGP peers of the migrating network must be updated to maintain network reachability.
Essentially, Local-AS provides a capability to the BGP speaker to operate as if it belongs to "virtual" AS network besides its physical
AS network.
The following illustration shows a scenario where Router A, Router B, and Router C belong to AS 100, 200, and 300, respectively.
Router A acquired Router B; Router B has Router C as its customer. When Router B is migrating to Router A, it must maintain the
connection with Router C without immediately updating Router C's configuration. Local-AS allows this behavior to happen by
allowing Router B to appear as if it still belongs to Router B's old network (AS 200) as far as communicating with Router C is
concerned.
Figure 23. Before and After AS Number Migration with Local-AS Enabled
When you complete your migration, and you have reconfigured your network with the new information, disable this feature.
160
Border Gateway Protocol IPv4 (BGPv4)