Dell Force10 Z9000 Configuration Manual page 308

3. Access CONFIGURATION mode.
EXEC Privilege mode
config
4. Access the port.
CONFIGURATION mode
interface interface slot/port
5. Set the local port speed.
INTERFACE mode
speed {10 | 100 | 1000 | auto}
6. Optionally, set full- or half-duplex.
INTERFACE mode
duplex {half | full}
7. Disable auto-negotiation on the port.
INTERFACE mode
no negotiation auto
If the speed was set to 1000, do not disable auto-negotiation.
8. Verify configuration changes.
INTERFACE mode
show config
Example of the show interfaces status Command to View Link Status
NOTE: The show interfaces status command displays link status, but not administrative status. For both link and
administrative status, use the show ip interface [interface | brief | linecard slot-number]
[configuration] command.
Dell#show interfaces status
Port Description Status Speed
Te 1/1 Down
Te 1/2 Down
Te 1/3 Down
Te 1/4 Force10Port Up
Te 1/5 Down
Te 1/6 Down
Te 1/7 Up
Te 1/8 Down
Te 1/9 Down
Te 1/10 Down
Te 1/11 Down
Te 1/12 Down
[output omitted]
In the previous example, several ports display "Auto" in the Speed field. In the following example, the speed of port 1/1 is set to
100Mb and then its auto-negotiation is disabled.
Dell#configure
Dell(config)#interface tengig 1/1
Dell(conf-if-te-1/1)#speed 100
Dell(conf-if-te-1/1)#duplex full
Dell(conf-if-te-1/1)#no negotiation auto
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
308
Interfaces
Duplex Vlan
1000 Mbit Auto 1
Auto Auto 1
Auto Auto --
1000 Mbit Auto 30-130
Auto Auto --
Auto Auto --
1000 Mbit Auto 1502,1504,1506-1508,1602
Auto Auto --
Auto Auto --
Auto Auto --
Auto Auto --
Auto Auto --