Dell Force10 Z9000 Configuration Manual page 832

• Change the dedicated buffers on a physical 1G interface.
BUFFER PROFILE mode
buffer dedicated
• Change the maximum number of dynamic buffers an interface can request.
BUFFER PROFILE mode
buffer dynamic
• Change the number of packet-pointers per queue.
BUFFER PROFILE mode
buffer packet-pointers
• Apply the buffer profile to a line card.
CONFIGURATION mode
buffer fp-uplink linecard
• Apply the buffer profile to a CSF to FP link.
CONFIGURATION mode
buffer csf linecard
Displaying the Default Buffer Profile
Displaying Buffer Profile Allocations
Dell Networking OS Behavior: If you attempt to apply a buffer profile to a non-existent port-pipe, Dell Networking OS displays the
following message. However, the configuration still appears in the running-config.
%DIFFSERV-2-DSA_BUFF_CARVING_INVALID_PORT_SET: Invalid FP port-set 2 for linecard 2. Valid
range of
port-set is <0-1>
Configuration changes take effect immediately and appear in the running configuration. Because, under normal conditions, all ports
do not require the maximum allocation, the configured dynamic allocations can exceed the actual amount of available memory; this is
called oversubscription. If you choose to oversubscribe the dynamic allocation, a burst of traffic on one interface might prevent other
interfaces from receiving the configured dynamic allocation, which causes packet loss.
You cannot allocate more than the available memory for the dedicated buffers. If the system determines that the sum of the
configured dedicated buffers allocated to the queues is more than the total available memory, the configuration is rejected, returning
a syslog message similar to the following.
00:04:20: %S50N:0 %DIFFSERV-2-DSA_DEVICE_BUFFER_UNAVAILABLE: Unable to allocate dedicated
buffers for
stack-unit 0, port pipe 0, egress port 25 due to unavailability of cells
Dell Networking OS Behavior: When you remove a buffer-profile using the no buffer-profile [fp | csf] command from
CONFIGURATION mode, the buffer-profile name still appears in the output of the show buffer-profile [detail |
summary] command. After a line card reset, the buffer profile correctly returns to the default values, but the profile name remains.
Remove it from the show buffer-profile [detail | summary] command output by entering the no buffer [fp-
uplink |csf] linecard port-set buffer-policy command from CONFIGURATION mode and the no buffer-
policy command from INTERFACE mode.
Display the allocations for any buffer profile using the show commands, shown in the following examples. Display the default buffer
profile using the show buffer-profile {summary | detail} command from EXEC Privilege mode, also shown in the
following examples.
Dell#show buffer-profile detail interface gigabitethernet 0/1
Interface Gi 0/1
Buffer-profile -
Dynamic buffer 194.88 (Kilobytes)
832
Z-Series Debugging and Diagnostics