Assigning Ip Addresses To An Interface; Configuring Static Routes - Dell Force10 Z9000 Configuration Manual
Hide thumbs
Also See for Force10 Z9000:
- Reference manual (1483 pages) ,
- Configuration manual (984 pages) ,
- Manual (56 pages)
Table of Contents
Advertisement
Assigning IP Addresses to an Interface
Assign primary and secondary IP addresses to physical or logical (for example, [virtual local area network [VLAN] or port channel)
interfaces to enable IP communication between the system and hosts connected to that interface.
In Dell Networking OS, you can assign one primary address and up to 255 secondary IP addresses to each interface.
1.
Enter the keyword interface then the type of interface and slot/port information.
CONFIGURATION mode
interface interface
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
•
For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1. The port range is 0.
•
For a port channel interface, enter the keywords port-channel then a number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
2.
Enable the interface.
INTERFACE mode
no shutdown
3.
Configure a primary IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
•
ip-address mask: the IP address must be in dotted decimal format (A.B.C.D). The mask must be in slash prefix-length
format (/24).
•
secondary: add the keyword secondary if the IP address is the interface's backup IP address. You can configure up to
eight secondary IP addresses.
Example the show config Command
To view the configuration, use the show config command in INTERFACE mode or use the show ip interface command in
EXEC privilege mode, as shown in the second example.
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/1
ip address 10.11.1.1/24
no shutdown
!
Configuring Static Routes
A static route is an IP address that you manually configure and that the routing protocol does not learn, such as open shortest path
first (OSPF). Often, static routes are used as backup routes in case other dynamically learned routes are unreachable.
You can enter as many static IP addresses as necessary.
To configure a static route, use the following command.
•
Configure a static IP address.
CONFIGURATION mode
317
IPv4 Routing
Advertisement
Table of Contents
Troubleshooting
