Dell Force10 Z9000 Configuration Manual page 473

Location Description
•
•
2/11
•
•
•
•
2/31
•
•
•
•
3/1
•
•
•
•
3/11
•
•
•
3/21 •
•
•
•
•
Receiver 1
•
•
•
•
•
Receiver 2
•
•
•
•
Preventing a PIM Router from Processing a Join
To permit or deny PIM Join/Prune messages on an interface using an extended IP access list, use the following command.
NOTE: Dell Networking recommends not using the ip pim join-filter command on an interface between a source
and the RP router. Using this command in this scenario could cause problems with the PIM-SM source registration
process resulting in excessive traffic being sent to the CPU of both the RP and PIM DR of the source.
Excessive traffic is generated when the join process from the RP back to the source is blocked due to a new source group
being permitted in the join-filter. This results in the new source becoming stuck in registering on the DR and the continuous
generation of UDP-encapsulated registration messages between the DR and RP routers which are being sent to the CPU.
• Prevent the PIM SM router from creating state based on multicast source and/ or group.
ip pim join-filter
no shutdown
Interface TenGigabitEthernet 2/11
ip pim sparse-mode
ip address 10.11.12.2/24
no shutdown
Interface TenGigabitEthernet 2/31
ip pim sparse-mode
ip address 10.11.23.1/24
no shutdown
Interface TenGigabitEthernet 3/1
ip pim sparse-mode
ip address 10.11.5.1/24
no shutdown
Interface TenGigabitEthernet 3/11
ip pim sparse-mode
ip address 10.11.13.2/24
no shutdown
Interface TenGigabitEthernet 3/21
ip pim sparse-mode
ip address 10.11.23.2/24
no shutdown
Interface VLAN 300
ip pim sparse-mode
ip address 10.11.3.1/24
untagged TenGigabitEthernet 1/1
no shutdown
Interface VLAN 400
ip pim sparse-mode
ip address 10.11.4.1/24
untagged TenGigabitEthernet 1/2
no shutdown
473
Multicast Features