Mig/Mag And Cmt Welding Parameters; Welding Parameters For Mig/Mag Pulse Synergic Welding, For Cmt Welding And Pmc Welding - Fronius TPS 320i Operating Instructions Manual

MIG/MAG and CMT welding parameters

Welding parame- The following welding parameters for MIG/MAG pulse synergic welding, CMT welding and
ters for MIG/MAG PMC welding can be set and displayed by pressing the "Welding" button:
pulse synergic
welding, for CMT
Current
welding and PMC
welding
Unit
Setting range
Before the start of welding, the machine automatically displays a standard value based
on the programmed parameters. The actual value is displayed during welding.
Voltage
Unit
Setting range
Before the start of welding, the machine automatically displays a standard value based
on the programmed parameters. The actual value is displayed during welding.
Material thickness
Unit
Setting range
Wire speed
Unit
Setting range
Arc length correction
For correcting the arc length
Setting range
Factory setting
-
0
+
Pulse/dynamic correction
For correcting the pulsing energy of a pulsed arc
Setting range
Factory setting
-
0
+
74
1)
A
Depends on the welding process and welding program selected
1)
V
Depends on the welding process and welding program selected
1)
mm
0.1 - 30.0 mm
1)
m/min
0.5 - max.
-10 - +10
0
shorter arc length
neutral arc length
longer arc length
-10 - +10
0
lower droplet detachment force
neutral droplet detachment force
higher droplet detachment force
in.
2)
0.004 - 1.18
ipm
2) 3)
19.69 - max
2)
2) 3)