Mig/Mag Standard Manual Welding; General; Adjustable Welding Parameters For Mig/Mag Standard Manual - Fronius Welducation Simulator Operating Instructions Manual

MIG/MAG Standard Manual Welding

General

The MIG/MAG standard manual welding process is a MIG/MAG welding process
with no synergic function.
Changing one parameter does not result in any automatic adjustments to the
other parameters – all variable parameters must be adjusted individually.
Adjustable weld- The following parameters are available for MIG/MAG standard manual welding:
ing parameters
for MIG/MAG
standard manual
MIG/MAG The following settings, which are made on the power source in reality, are made
standard manual in the simulation using the Welducation Campus software:
welding -
-
-
1
2
3
4
Danger from objects falling or toppling over
Toppling or falling objects may cause serious injuries and damage to property.
▶
▶
▶
▶
▶
▶
Wire speed
Welding voltage
Selecting the welding processes
Selecting and setting the welding parameters
The display of the amount of shielding gas set by means of the knob on the
Welducation Simulator
Select the MANUAL process.
Select the desired MIG/MAG operating mode:
2-step mode
4-step mode
In MIG/MAG standard manual welding, special 4-step mode corresponds to
conventional 4-step mode.
Select and set the wire speed parameter.
Select and set the welding voltage parameter.
WARNING!
Choose a load-bearing and level table / surface on which to set up the stand.
Set up the stand in such a way that it is held securely and cannot topple or
fall down.
After the adjustment process, tighten the adjusting screws on the stand so
that the stand is stable and able to support a load.
When positioning the workpiece, ensure that the workpiece rests flush
against the magnet.
Ensure that the clamp for the return lead cable is securely seated.
Ensure the interaction target is held securely in place.
53