Commissioning the TPS 320i / 400i / 500i / 600i, TPS
400i LSC ADV
Safety
General
A manual water-cooled MIG/MAG application is used to describe how to commission the
TPS 320i / 400i / 500i / 600i and TPS 400i LSC ADV power sources.
The following illustrations provide an overview of the structure of the individual system
components.
Refer to the respective system component operating instructions for detailed information
about the various work steps involved.
56
WARNING! An electric shock can be fatal. If the power source is connected to the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Before carrying out any work on the device make sure that:
-
the power source mains switch is in the "O" position
-
the power source is unplugged from the mains