Control Panel; General; Safety - Fronius TPS 320i Operating Instructions Manual

Control panel

General

Welding parameters can be easily changed and selected using the adjusting dial.
The parameters are shown on the display while welding is in progress.
The synergic function ensures that other welding parameters are also adjusted whenever
an individual parameter is changed.

Safety

Control panel
NOTE! As a result of firmware updates, you may find that your device has certain
functions that are not described in these operating instructions, or vice versa. Cer-
tain illustrations may also differ slightly from the actual controls on your device,
but these controls function in exactly the same way.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
(1) (2) (3) (4) (5) (6)
37