System Calibration - Fronius TPS 320i Operating Instructions Manual

3
If system calibration is required, the system calibration wizard starts. The first step in the
system calibration wizard is displayed:
4
5
When system calibration has been completed successfully, a confirmation to this effect is
displayed.
6
System calibra- If two motors are used in a welding system, they need to be calibrated to maintain process
tion stability.
System calibration must be carried out on welding systems with PushPull units or unreeling
wirefeeders following successful installation or replacement of a wirefeeder.
A notification will be displayed.
1
The system calibration wizard starts.
2
System calibration can also be started manually here.
Select "system adjust"
Follow the displayed instructions
To move to the next step in the wizard, select "Next" / press the adjusting dial
To close the system calibration wizard, select "Finish" / press the adjusting dial
Select "OK" and start system calibration
Follow the instructions shown
3
117