R/L-Check / Alignment - Fronius TPS 320i Operating Instructions Manual

R/L-check / align- Align the welding circuit resistance (R) and welding circuit inductivity (L) if one of the fol-
ment lowing components of the welding system is changed:
-
-
-
-
-
-
Prerequisites for R/L alignment:
The welding system must be complete: closed welding circuit with torch and torch hose-
pack, wirefeeders, grounding cable, interconnecting hosepacks.
Performing R/L alignment:
1
2
The current welding circuit inductivity and welding circuit resistance values are displayed.
3
The second step of the R/L alignment wizard appears.
4
5
The third step of the R/L alignment wizard appears.
6
7
The fourth step of the R/L alignment wizard appears.
Torch hosepacks
Interconnecting hosepacks
Grounding cables, welding power-leads
Wirefeeders
Welding torches, electrode holders
PushPull units
1
Select "Process parameters"
Select "R/L-check / alignment"
Select "Next" / press the adjusting dial / press the torch trigger
Follow the displayed instructions
IMPORTANT! Contact between the earthing clamp and workpiece must be estab-
lished on a cleaned area of the workpiece.
Select "Next" / press the adjusting dial / press the torch trigger
Follow the displayed instructions
Select "Next" / press the adjusting dial / press the torch trigger
2
105