Process Parameters For Process Mix - Fronius TPS 320i Operating Instructions Manual

Process parame- The following process parameters for mixed processes can be set under "Process mix":
ters for Process
mix
Mixed process between PMC and LSC welding process. A cold LSC process phase follows a hot PMC process
phase as part of a cycle.
Mixed process between PMC and wire movement reversal using a PushPull drive unit. A cold low current char-
ging phase follows a hot PMC process phase with calibration movement.
Mixed process between CMT and PMC welding process. Cold CMT process phases follow hot PMC process pha-
ses.
(1)
(2)
(3)
112
I [A]
v [m/min]
D
(1)
I [A]
v [m/min]
D
(1)
(2)
I [A]
v [m/min]
D
(1)
Lower power correction
Lower power time correction
Upper power time correction
PMC mix
(2)
PMC mix drive
CMT mix
(2)
(3)
(3)
(3)
t [ms]
t [ms]
t [ms]