Locking And Unlocking The Power Source Using A Keycard Or Key Ring; General - Fronius TPS 320i Operating Instructions Manual

Locking and unlocking the power source using a
keycard or key ring

General

The power source can be locked using a keycard or key ring, e.g. to prevent unauthorised
access or welding parameters being changed without permission.
A contactless system on the control panel allows the power source to be locked and un-
locked.
The power source must be switched on before it can be locked or unlocked.
Locking and un- Locking the power source
locking the power
source using a
keycard or key
ring
1
The key symbol appears on the display.
The key symbol is then displayed in the status bar.
The power source is now locked.
Only the welding parameters can be viewed and adjusted using the adjusting dial.
Any attempt to call a locked function will result in a notification being displayed.
Unlocking the power source
1
The crossed-out key symbol appears on the display.
The key symbol no longer appears in the status bar.
All power source functions are now available again without restrictions.
64
Hold the keycard or key ring up to the keycard reader
Hold the keycard or key ring up to the keycard reader