Options - Fronius TPS 320i Operating Instructions Manual

Options

OPT/i TPS 2.SpeedNet Connector
Optional second SpeedNet connection socket
Factory-installed on the rear of the power source (but can also be installed on the front of
the power source).
OPT/i TPS 4x Switch SpeedNet
Option if more than one additional SpeedNet connection socket is required.
IMPORTANT! The OPT/i TPS 4x Switch SpeedNet option cannot be operated in conjunc-
tion with the OPT/i TPS 2. SpeedNet Connector option. If the OPT/i TPS 2.SpeedNet
Connector option is installed in the power source, it must be removed.
OPT/i TPS SpeedNet Connector
Expansion of the OPT/i TPS 4x Switch SpeedNet option
Can only be used in conjunction with the OPT/i TPS 4x Switch SpeedNet option, maxi-
mum of 2 per power source
OPT/i TPS 2nd NT241 CU 1400i
Where a CU 1400 cooling unit is used, the OPT/i TPS 2nd NT241 CU1400i option must
be installed in TPS 320i - 600i power sources .
OPT/i TPS motor supply +
If three or more drive motors are to be operated in the welding system, the OPT/i TPS
motor supply + option must be installed in the TPS320i - 600i power sources.
OPT/i TPS dust filter
IMPORTANT! Use of the OPT/i TPS dust filter option on TPS 320i - 600i power sources
shortens the duty cycle.
OPT/i TPS 2nd plus socket PC
2nd (+) current socket (Power Connector) on the front of the power source (option)
OPT/i TPS 2nd earth socket
2nd (-) current socket (Dinse) on the rear of the power source (option)
OPT/i TPS 2nd DINSE plus socket
2nd (+) current socket (Dinse) on the front of the power source (option)
OPT/i TPS 2nd earth socket PC
2nd (-) current socket (Power Connector) on the rear of the power source (option)
OPT/i SpeedNet Repeater
Signal amplifier if interconnecting hosepacks or connections from the power source to the
wirefeeder are more than 50 m in length
OPT/i Synergic Lines
Option for enabling all special characteristics available on TPSi power sources;
this also automatically enables special characteristics created in future.
OPT/i GUN Trigger
Option for special functions in conjunction with the torch trigger
OPT/i Jobs
Option for Job mode
OPT/i Documentation
Option for the documentation function
OPT/i Interface Designer
Option for individual interface configuration
OPT/i WebJobEdit
Option for editing jobs via the power source website
32